Ised - Infineon AIROC CYW20822-P4TAI040 Manual

AIROC™ Bluetooth® LE module
Regulatory information
RF EXPOSURE:
To comply with FCC RF Exposure requirements, the Original Equipment Manufacturer (OEM) must ensure to
install the approved antenna in the previous.
The preceding statement must be included as a CAUTION statement in manuals, for products operating with the
approved antenna in Table 7, to alert users on FCC RF Exposure compliance. Any notification to the end user of
installation or removal instructions about the integrated radio module is not allowed.
The radiated output power of CYW20822-P4xxI040 with the trace antenna is far below the FCC radio frequency
exposure limits. Nevertheless, use CYW20822-P4xxI040 in such a manner that minimizes the potential for human
contact during normal operation.
SAR is not required for this module if the distance is greater than 10 mm from the user.
End users may not be provided with the module installation instructions. OEM integrators and end users must be
provided with transmitter operating conditions for satisfying RF exposure compliance.
9.2

ISED

Innovation, Science and Economic Development Canada (ISED) Certification
CYW20822-P4xxI040 is licensed to meet the regulatory requirements of Innovation, Science and Economic Devel-
opment Canada (ISED),
License: IC: TBD
Manufacturers of mobile, fixed, or portable devices incorporating this module are advised to clarify any
regulatory questions and ensure compliance for SAR and/or RF exposure limits. Users can obtain Canadian infor-
mation on RF exposure and compliance from www.ic.gc.ca.
This device has been designed to operate with the antennas listed in Table 7, having a maximum gain of –0.5 dBi.
Antennas not included in this list or having a gain greater than –0.5 dBi are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms. The antenna used for this transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
ISED NOTICE:
The device CYW20822-P4xxI040 including the built-in trace antenna complies with Canada RSS-GEN Rules. The
device meets the requirements for modular transmitter approval as detailed in RSS-GEN. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
L'appareil CYW20822-P4xxI040, y compris l'antenne intégrée, est conforme aux Règles RSS-GEN de Canada.
L'appareil répond aux exigences d'approbation de l'émetteur modulaire tel que décrit dans RSS-GEN.
L'opération est soumise aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences
nuisibles, et (2) Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner
un fonctionnement indésirable.
ISED INTERFERENCE STATEMENT FOR CANADA
The antenna of this transmitter must provide a separation distance of at least 10 mm from all persons. Installers
and end-users
must be provided with antenna installation instructions and transmitter operating conditions and instructions
for satisfying RF
exposure compliance.
Compliance of this device in all final product configurations is the responsibility of the Grantee.
Installation of this device into specific final products may require the submission of a Class II permissive change
application, containing data pertinent to RF Exposure, emissions and host/module authentication, or new appli-
Preliminary Datasheet 20 002-38449 Rev. **
2023-08-21