Table of Contents
Advertisement
AIROC™ Bluetooth® LE module
Regulatory information
18
Regulatory information
18.1
FCC
FCC NOTICE:
The device CYBLE-3x307x-02 complies with Part 15 of the FCC Rules. The device meets the requirements for
modular transmitter approval as detailed in FCC public Notice DA00-1407.transmitter Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
CAUTION:
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Infineon may void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
This module is only FCC authorized for the specific rule FCC 15.247 listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification, final host product requires Part 15 Subpart B compliance testing with
the modular transmitter installed.
LABELING REQUIREMENTS:
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. This includes
a clearly visible label on the outside of the OEM enclosure specifying the appropriate Infineon FCC identifier for
this product as well as the FCC Notice above. The FCC identifier is FCC ID: WAP3072.
In any case the end product must be labeled exterior with "Contains FCC ID: WAP3072".
ANTENNA WARNING:
This device is tested with a standard SMA connector and with the antenna listed in
integrated in the OEMs product, these fixed antennas require installation preventing end-users from replacing
them with non-approved antennas. Any antenna not in the following table must be tested to comply with FCC
Section 15.203 for unique antenna connectors and Section 15.247 for emissions.
Preliminary Datasheet
45 of 58
Table 7 on page
20. When
002-33419 Rev. **
2021-07-22
Advertisement
Table of Contents
