3M AC40 Series User Instruction Manual page 12

5.0 INSPECTION
5.1 INSPECTION FREQUENCY: The Rope Grab and Rope must be inspected at the intervals defined in Section 2.
Inspection procedures are described in the "Inspection & Maintenance Log" (Table 2).
Extreme working conditions (harsh environments, prolonged use, etc.) may require increasing the frequency of
;
inspections.
5.2 UNSAFE OR DEFECTIVE CONDITIONS: If inspection reveals an unsafe or defective condition, remove the
Rope Grab from service immediately and destroy to prevent inadvertent use. Rope Grab and Ropes are not
repairable.
5.3 PRODUCT LIFE: The functional life of 3M Rope Grab and Ropes is determined by work conditions and maintenance.
Maximum lifespan can range from 1 year for heavy use in extreme conditions to 10 years for light use in mild
conditions. As long as the product passes inspection criteria, it may remain in service up to a maximum of 10 years.
6.0 MAINTENANCE, SERVICE, STORAGE AND TRANSPORT
6.1 CLEANING: Clean the rope grab and lifeline with water and a mild soap solution. Wipe off hardware with a clean,
dry cloth, and hang to air dry. Do not force dry with heat. An excessive buildup of dirt, paint, etc. may prevent the
rope grab or lifeline from working properly, and in severe cases degrade the rope grab or rope to a point where it
has weakened and should be removed from service. If you have any questions concerning the condition of the rope
grab or lifeline, or have any doubt about putting them into service, contact 3M Fall Protection.
6.2 SERVICE: Rope Grab and Rope are not repairable. If the Rope Grab and Rope has been subjected to fall force, or
inspection reveals an unsafe or defective condition, remove the Rope Grab from service and discard. See Section
5.1 for inspection frequency.
6.3 STORAGE/TRANSPORT: Store and transport the rope grab and lifeline in a cool, dry, clean environment out of
direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the rope grab and lifeline after
any period of extended storage.
7.0 MARKINGS
7.1 Figure 12 illustrates product labels on the Rope Grab and Rope. All labeling must be present and fully legible.
Location: Label with markings is located on Rope Grab and under shrink tube on Rope .
Information on each label is as follows:
Figure 12 Reference:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Description:
Model number
Serial number
Batch number
Address of the Manufacturer
Read these instructions before use
European standard
CE Marking of European Conformity
Number of Notified body carrying out Conformity to type
Length
Month of manufacture
Year of manufacture
Web Address of the Manufacturer
Use with 3M 12,5 mm diameter Lifeline Rope Only
Capacity
12