Mounting The Electronics Module And Manifold Block - Festo CPX-4AE-4AA-H Operating Instructions Manual

Assembly
1
5
4
Fig. 6: Remove coding piece
1. Place the manifold block 4 on a flat surface with the top up.
2. Unlock and remove the cover 1.
3. Press out the coding piece 3 with a suitable tool 2.
4. Push the cover onto the plug of the manifold block 5.
5.3

Mounting the electronics module and manifold block

Requirements
– Supply voltage is switched off.
– The interlinking block is clean and free of foreign matter.
– DIL switches are set è Tab. 8 DIL switch settings.
Festo — CPX-4AE-4AA-H — 2021-06b
1
Cover with interlock
2
Tool (e.g. pin)
2
3
Coding piece
4
Manifold block
5
Plugs
3
13