Festo CPX-4AE-4AA-H Operating Instructions Manual page 12

Assembly
Inserting the coding piece into the manifold block
5
4
3
Fig. 5: Mechanical coding of the manifold block – example
1
Manifold block
2
Latching hook on coding piece
3
Interlinking block with electronics module
1. Place the interlinking block and electronics module 3 on a flat surface.
2. With the latching hook 2 facing upward, place the coding piece on the coding pin 4.
3. Align the plug of the manifold block with the plug of the electronics module.
4. Push the manifold block onto the electronics module without tilting until the coding piece in the
manifold block engages.
Removing coding piece from the manifold block
To change the device configuration, the coding piece might have to be removed from the manifold
block.
12
4
Coding pin
5
Coding piece
Festo — CPX-4AE-4AA-H — 2021-06b
1
2