Festo CPX-4AE-4AA-H Operating Instructions Manual page 14

Assembly
2 2
1
7
6
5
Fig. 7: Mounting of the electronics module and
connection block – example
1
Manifold block
Mounting the electronics module and manifold block
NOTICE
If threads are damaged or seals are defective, the device cannot achieve its specified IP degree of
protection.
Before mounting:
• Check the seals and thread. Replace damaged parts.
1. Check seal and seal surfaces. Replace damaged parts.
2. Place the electronics module in the interlinking block without tilting.
3. Press the electronics module to the stop.
4. Align the manifold block on the interlinking block with the electronics module.
5. Push the manifold block onto the interlinking block without tilting.
14
2
Screws T10
3
Electronics module
4
Busbars
5
Interlinking block
6
Coding pin
2
7
Plugs
2
3
4
Festo — CPX-4AE-4AA-H — 2021-06b