Prom Signature And Version; Available Proms/Library Options; B.2 Available Proms/Library Options; Description Of Library Options Not In Standard Manual - Campbell Measurement and Control Module CR10 Operator's Manual

APPENDIX B. CR10 PROM SIGNATURE AND OPTIONAL SOFTWARE
B.1 PROM SIGNATURE AND VERSION
The CR10 PROM signature is viewed by
entering the *B Mode and advancing to window
2 (Section 1.6). The version number is in
window 6 and the revision number in window 7.
PROM
DESCRIPTION
OS10-0.1
OS10-1.1
OS10-0.1-4K
INST. NO.
13,14
15
1
23
1
27,28
64
1
101
1
102
1
103,104
SDM Utilities
105,106
60
62
81
1
97
1
98
99
64
*4
*D
1
These instructions are in OS10-0.1 and are described in the standard manual.
B.2 AVAILABLE PROMS / LIBRARY
OPTIONS
The set of instructions available in the CR10 is
determined by the PROM (Programmable Read
Only Memory that it is equipped with. If the
standard PROM, OS10-0.1, does not fit the
customer's application it is possible to create a
library option PROM with the instructions and
features desired, provided the memory capacity
of the PROM is not exceeded.
TABLE B-1. CR10 PROM Signatures
SIGNATURE
*B, WINDOW 2
51903
55030
19464
TABLE B-2. CR10 Library Options
DESCRIPTION
Core files must be included
Add R, S, & B Thermocouple Linearizations
Control Port Serial I/O
Burst Measurement
Period, Vibrating Wire Measurement
Paroscientific "T" Series Processing
SDM-INT8
SDM-SW8A
SDM-AO4, SDM-CD16
216
SDI12 Recorder/Sensor
FFT
Covariance/Correlation
Rainflow histogram
Initiate telecommunications
Send Character
Satellite Interface
Hz Pulse counters reset
Parameter Entry Table
Add Tape up/down load
The signatures of current standard PROMs are
listed in Table B-1. If the CR10 has a Library
Option PROM, the signature is listed on the
calibration sheet shipped with the datalogger.
The instructions for using the special features,
can be found in Appendix H.
PROM NUMBER
*B, WINDOW 6
.10000
1.1000
90.100
Library Option PROMS are assembled from a
base set of instructions plus selected functions
in Table B.2-1. Consult a Campbell Scientific
applications engineer for pricing and help in
configuring a library option.
B.3 DESCRIPTION OF LIBRARY OPTIONS
NOT IN STANDARD MANUAL
The following is a brief description of library
options not found in the standard manual. If the
REVISION NUMBER
WINDOW 7
0001
0001
0000
BYTES
2578
456
1111
1588
932
169
549
268
239
1528
2297
796
1159
880
73
3143
-3
575
1196
B-1