Advertisement
CAUTION: Do Not force the door panel to move, as doing so may result in breakage and risk of injury. If the following steps do not resolve the
associated symptoms or for any questions, call Liberty Hardware's Customer Care at 1-800-964-4850.
Symptom: Operation (open/close)
1. The outside panel is difficult to move.
2. The inside panel is difficult to move.
Symptom: Alignment
1. The top side of the glass panel is tilted away from the
wall jamb.
2. The bottom side of the glass panel is tilted away from
the wall jamb.
3. The top track is cut too short.
4. The bottom track is cut too short.
5. The glass panels do not track into the bottom grab
bumpers.
Symptom: Water Leaks
1. Water leaks between panels.
2. Water leaks between wall jamb and the glass panel.
3. Water leaks under the bottom track.
4. Water leaks over bottom track.
Symptom: Maintenance
1. Excess noise or vibration.
2. Track kit discoloration.
TROUBLESHOOTING / SOLUCIÓN DE PROBLEMAS
Recommended Action
a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the outer rollers.
b. Ensure the panel is properly engaged over the center divider. See step 52.
c. Ensure the inside center guide is properly secured with self-tapping screw. See step 52.
d. Ensure the rollers are properly installed.
e. Clean any debris in the top track where the rollers operate.
a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the inner rollers.
b. Ensure the panel is properly engaged over the center divider. See step 52.
c. Ensure the inside center guide is properly secured with self-tapping screw. See step 52.
d. Ensure the rollers are properly installed.
e. Clean any debris in the top track where the rollers operate.
Recommended Action
Carefully remove the glass panel from the top track and raise the roller on the bracket closest to the wall jamb.
Note: To remove the inner panel, the center guide will first need to be uninstalled.
Carefully remove the glass panel from the top track and lower the roller on the bracket that is closest to the wall jamb.
Note: To remove the inner panel, the center guide will first need to be uninstalled.
Top track must be cut correctly. See steps 26-28. If top track was cut incorrectly, call Liberty Hardware's Customer Care
at 1-800-964-4850.
Seal as directed to ensure watertight seal. See steps 61 and 62. If additional sealant is insufficient, call Liberty Hardware's
Customer Care at 1-800-964-4850.
Loosen the screw of the bottom grab bumper and adjust the position of the bumper using the alignment slot. If the bumper
needs to move towards the front of the enclosure, rotate bumper so locating leg is oriented towards interior of enclosure.
Recommended Action
a. When showering, make sure the inside panel is closest to the showerhead wall.
b. Ensure blade seals (E) are properly installed. See Step 59.
For adjustment, see Symptom: Alignment.
Check for proper silicone sealant application. See steps 61 and 62. Apply more silicone sealant as needed.
Ensure that inner overhang of bottom track is free of sealant.
Recommended Action
a. Check all fasteners and re-tighten as necessary.
b. Ensure bushings (DD) are installed in glass.
Carefully review and follow Care and Cleaning Instructions.
45
Advertisement
