Santak ARRAY 4 User Manual page 20

Table of Contents

Advertisement

6. OPERATION OF ADDING / REMOVING UPS-MODULES
6.2.2 Procedures of removing the UPS-Module
1) Remove the plastic cover panel from the position where you want to remove the
UPS-Module.
2) Use two hands to hold the handle and press the latch-levers in the handle units to
slide the UPS-Module slowly out of the frame until you see the marks "●"on the top
of the UPS-Module, then hold the UPS-Module on the left and right sides to pull it out
from the frame.
Note
Do not use too much strength when pulling the module to avoid it dropping.
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ARRAY 4 and is the answer not in the manual?

Table of Contents