5. INSTALLATION
5.2 Space requirement
A recommended space of 80cm and 30cm from the front panel and the rear panel
respectively should be reserved for ventilation and future maintenance. Keep the
surroundings clean and don't place any objects close to the UPS.
5.3 Installation
DOWN
1)Place the unit in its intended location and then turn the four brake pads counter-clockwise
with a wrench until they reach tightly against the floor to secure the unit. The brake pads
are at the four corners of the bottom of the frame.
2) Insert the Communication Module into the bay at the top left corner of the frame (Refer to
Fig.5).
3) Insert the Charger Module into the bay at the top right corner of the frame if any. (Refer
to Fig.6)
Brake Pad
UP
Fig.4
Fig.5
14
Fig.6
Need help?
Do you have a question about the ARRAY 4 and is the answer not in the manual?