Save & Exit - Avnet COM Express MSC C6C-AL User Manual

Feature
USB Support
PS2 Devices Support
Network Stack Driver
Support
Redirection Support
New Boot Option Policy
6.12 Save & Exit
The following sections describe each of the options in this menu.
Save Changes and Exit
After making changes in the setup menus, always select "Exit Saving Changes". This procedure stores the selections displayed in the menus in a flash.
The next time you boot your computer, the BIOS configures your system according to the setup selections stored in flash.
If you attempt to exit without saving, the program asks if you want to save before exiting. During boot-up, the Aptio BIOS attempts to load the values
saved in flash. If those values cause the system boot to fail, reboot and press
Values (as described below) or try to change the selections that caused the boot to fail.
Discard Changes and Exit
Exit system setup without saving any changes.
MSC C6C-AL
Options Description
Disabled, Full Initial, Partial If Disabled, all USB devices will NOT be available until after OS
Initial boot. If Partial Initial, USB Mass Storage and specific USB
port/device will NOT be available before OS boot. If Full Initial, all
USB devices will be available in OS and Post.
Note: If disabled, entering Setup will only be possible by performing
a System Reset ( with Reset Button ) during OS Boot, or by clearing
CMOS with the Clear CMOS Jumper.
Enabled, Disabled If disabled, PS2 devices will be skipped
Enabled, Disabled If disabled, Network Stack driver will be skipped
Enabled, Disabled If disabled, Redirection function will be disabled
Default, Place First, Place Controls the placement of newly detected UEFI boot options
Last
MSC C6C-AL User Manual
[ESC] [DEL]
or to enter Setup. In Setup, you can restore the Default
104 / 128