Completing The Cdf - Quantum Data 980 User Manual

980 User Guide – MHL Compliance Tests
This procedure assumes that you have assembled the 882E/EA, Host PC, 980 Protocol Scope and sink device
under test and applied power to all these devices. Refer to the procedures and diagram below.
1. Connect an Ethernet cable from your PC hosting the external GUI Manager to an Ethernet jack on your
corporate network or Ethernet hub.
2. Connect an Ethernet cable from the 882E/EA to an Ethernet jack on your corporate network or Ethernet hub.
3. Connect an Ethernet cable from the 980 Ethernet jack on the lower left half of the back panel of the 980
Protocol Analyzer frame to an Ethernet jack on your corporate network or Ethernet hub. The IP address on this
980 port is configurable using the procedures in
Refer to the diagram below.
1
4.3

Completing the CDF

Use the following procedures to complete the CDF.
To complete the CDF:
1. From the View menu, enable viewing of the MHL Sink Compliance Test panel.
Page 53
Connection Scenarios for 980 Manager to 980 Protocol
Rev. B29
Scope.
July 26, 2011