Installation Using L-Brackets - Pilz PSEN ml s 1.1 Operating Manual

Installation
8.3.3

Installation using L-brackets

1. Use two M6 screws to fix the mounting bracket to the gate. The position of the drill
holes can be taken from the section entitled Dimensions.
2. Use four M5 screws to fix the safety switch to the mounting bracket.
Operating Manual PSEN ml s 1.1/2.1/2.2
1004710-EN-05
NOTICE
Correct distances when installing the actuator
The actuator must be attached at the same distance to the mounting sur-
face as the safety switch.
If the safety switch is installed using a mounting plate, then the actuator
must also be installed using a mounting plate (see Install actuator on
mounting plate).
Actuator, with mounting bracket
Provide the mounting surface with tapped
holes for two M6 screws (see Dimensions).
(Diagram: Order no. 570 476)
| 44