Pilz PSEN ml s 1.1 Operating Manual page 56

Installation
Fastening for the escape release (order no. 570463)
The escape release is fastened using a bracket (not in the Pilz portfolio). The bracket must
have the following properties:
}
Corrosion-resistant material
} Material thickness: 4 +/- 0.5 mm
}
Only low elastic deformation may occur at a force of 150 N. The cable must be able to
move with it.
Fasten escape release:
}
Insert the cylinder through the hole in the bracket [1].
}
Install the retaining ring [3] using circlip pliers for outer rings.
}
Pull the piston rod [2] out completely.
}
Apply a threadlocking adhesive evenly on the thread of the piston rod and then turn the
red button handle [4] as far as it will go.
}
Leave the adhesive to set for min. 24 hours.
Legend
Operating Manual PSEN ml s 1.1/2.1/2.2
1004710-EN-05
[1]
[3]
[1] Bracket (not in the Pilz portfolio)
[2] Cylinder
[3] Retaining ring
[4] Button handle
[2]
[4]
| 56