Advertisement
73.
Position and attach Vertical Door Flange on
inside edge of door frame (left door from outside)
using 6 - 2" Screws.
74.
The Interior Cane Bolt will be attached to Vertical Door Flange. To
position Cane Bolt correctly, attach to flange first, close doors and mark
hole to house Cane Bolt Rod. Open doors and drill hole where previously
marked with 1/2" bit. Attach Cane Bolt with 3/4" black screws.
75.
Attach Door Handles and Exterior Black Barrel Bolt to door. Attach Barrel
Bolt as illustrated above with 5 - 2" Black Screws & 1 - 3/4" Black Screw. Note
how female part of Barrel Bolt is positioned higher than male. Do a dry run first
to position Barrel Bolt correctly. Attach each Door Handle with 4 - 3/4" Black
Screws, ensure screws connect with inner door stud.
Important: Drill pilot holes with 1/8" drill bit prior to securing with screws to pre-
vent wood splitting.
Toll Free 1-888-658-1658
Inside Edge of
Door Frame
www.outdoorlivingtoday.com
Page 40
Parts
Interior Door Flange
(1/2" x 2 1/2" x 71") x 1
Drill 1/2" Diameter Hole to
accommodate rod of Cane Bolt.
Y6 - Cane Bolt x 1 total
SB1 - 3/4" Black Screws
Y3 - Door Handles x 2 total
sales@outdoorlivingtoday.com
Hardware
S3 - 2" Screws
x 6 total
Hardware
x 6 total
Hardware
Y4 - Barrel Bolt x 1 total
SB1 - 3/4" Black Screws
x 9 total
SB2 - 2" Black Screws
x 5 total
Advertisement
