Advertisement
14.
For each Solid Wall Panel, carefully lay panel
face down. Position and attach a Bottom Wall
Plate to bottom of wall studs of each wall panel with
3 - 2 1/2" Screws. Position so plates are flush with
framing.
1st Side Wall Panel
1/2"
overhang
Flush with
Floor Framing
Important - Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is
facing up or down? Compare solid wall
siding to window wall siding and match
orientation.
15.
Starting at Rear Corner, position a Solid Side Wall panel on top of Plywood Floor. The Wall Panel
bottom framing will sit flush with Floor framing. Wall siding will overhang the floor. The Side Wall panels
will sit flush at the end of the Plywood Floor with the Rear Wall panels sandwiched between them.
Note: Siding will overhang the Floor by approximately 1/2".
Toll Free 1-888-658-1658
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior
to screwing. This will make it
much easier to attach
together.
Bottom Wall Plate
www.outdoorlivingtoday.com
Page 12
Parts
Solid Wall Panels
(45 1/2" x 75") x 7
Bottom Wall Plates
(1 1/2" x 2 1/2" x 45 1/2") x 7
Do Not Attach Walls To
Floor Until Step 23
sales@outdoorlivingtoday.com
Pilot Hole
first.
Hardware
S1 - 2 1/2" Screws
x 21 total
1st Side
Wall Panel
Advertisement
