Advertisement
Alternate Ridge Cap seams
(Offsetting angle cut at peak)
66.
Place 1st Roof Ridge Cap on roof peak overhanging
shingles by approximately 1". Attach with 2 - 1 1/2" Shingle
Nails 9" from end. Place 2nd Ridge Cap 1" back from 1st cap.
Attach with 2 - 1 1/2" Shingle Nails 9" from end. Alternate each
Ridge Cap seam as you proceed.
67.
Place 3rd Ridge Cap 8" back from 2nd (enough to cover shingle
nails). Attach 3rd Ridge Cap as per Step 66. Continue to position
and attach Ridge Caps until half the roof is complete.
From opposite side, position and attach Ridge Caps as described
above. One Ridge Cap is cut shorter to fit in the center of the
Attach center cap with 4 - 1 1/2" Shingle Nails.
Toll Free 1-888-658-1658
Important: Butt (thick) end
of Ridge Cap will be facing
towards the outside of shed.
8"
www.outdoorlivingtoday.com
Page 37
Parts (Steps 66 - 67)
Roof Ridge Caps x 22
Hardware (Steps 66 - 67)
N2 - 1 1/2" Shingle Nails
x 46 total
roof.
sales@outdoorlivingtoday.com
Thin end
Thick end
Advertisement
