Advertisement
Advice: Prior to fastening walls and installing rafters, take time to confirm your walls are level, square and plumb.
Measure diagonal at top and bottom of walls corner-to-corner. This should be approximately 159 7/8". More importantly,
if measurements are not within 1/4", your walls are not square. Adjusting now will make it easier to install roof section
Optional - Caulking
seams will help prevent
moisture from entering
your shed.
Caulking
not included in kit.
23.
When all walls are attached together, check alignment with the floor. Bottom
of wall frames should sit flush with outside of floor framing, with siding overhanging
by approximately 1/2". Confirm 64" wide door opening at bottom. When positioned
correctly, fasten Bottom Wall Plates to floor using 4 - 2 1/2" Screws per wall panel.
24.
Position Rear Top Plates on top of wall studs so they are flush on the inside. Together, the
plates should be centered evenly on the wall left to right. Attach by screwing down into top wall
framing with 3 - 2" Screws per plate.
Front & Rear Wall Top Plates - 4 Angle Cut End, 2 Straight Cut
Side Wall Top Plates - Angle Cut Edge
Toll Free 1-888-658-1658
Parts (Steps 24 - 25)
(3/4" x 2 1/2" x 32") x 6
(3/4" x 2 1/2" x 65 3/4") x 4
www.outdoorlivingtoday.com
Pilot Hole
first.
Angle
screws into perimeter
Floor Joists.
Page 17
Hardware
S1 - 2 1/2" Screws
x 36 total
Hardware (Steps 24 - 25)
S3 - 2" Screws
x 34 total
sales@outdoorlivingtoday.com
.
Advertisement
