Table of Contents
Advertisement
Test mode
In manual mode (while the genset is OFF) if the Mode selection
mode is almost the same as manual mode, but in Test mode the genset contactor will not get latched. If the Genset contactor
latching
button is pressed, only the genset contactor gets latched. Once the genset starts in Test mode, the Test mode timer
starts. After the Stop/Config
stops according to the Stop sequence.
Acknowledge and clear alarms
NOTE
If Engine ON is detected without any start command is given to the controller, the engine will remain ON. Other actions will
be according to operating mode and configuration.
USER MANUAL 4189341243A UK
button is pressed or the timer has run out, the controller sends a Stop command and the genset
Shutdown Alarm
Warning Alarm
Notification
button is long pressed, the controller goes in Test mode. Test
•
Press the Acknowledge
the alarm in any mode.
button to acknowledge
Page 44 of 78
Advertisement
Table of Contents
