Table of Contents
Advertisement
6
Notes about this Documentation
1
Notes about this Documentation
Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1
Validity of this Documentation
This documentation is only applicable to the I/O module 750-652/040-000
(Serial Interface RS-232/RS-485 XTR).
The I/O module 750-652/040-000 shall only be installed and operated according to
the instructions in this manual, in the system description for the WAGO-I/O-
SYSTEM 750 XTR and in the manual for the used fieldbus coupler/controller.
Consider power layout of the WAGO-I/O-SYSTEM 750 XTR!
In addition to these operating instructions, you will also need the system
description "Design Notes XTR – Guidelines and Recommendations for
Increasing Operational Safety" and the manual for the used fieldbus
coupler/controller, which can be downloaded at www.wago.com. There, you can
obtain important information including information on electrical isolation, system
power and supply specifications.
1.2
Copyright
This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright provisions
is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the written
consent of WAGO Kontakttechnik GmbH & Co. KG, Minden, Germany. Non-
observance will involve the right to assert damage claims.
Manual
Version 1.3.0
750-652/040-000 Serial Interface RS-232/RS-485 XTR
WAGO-I/O-SYSTEM 750 XTR
Advertisement
Table of Contents
