Datcon DT9000 Operating Instructions Manual page 23

DT9000
Messages of critical
errors






During measuring


During code writing




During setting up







20171205-V2
A/D failure (Service: AD Hardware)
EEPROM failure (Service: EEPROM Hardware)
EEPROM write error (Service: EEPROM Protected)
Calibration error (Service: Calibration)
Default factory settings (Service: Default Factory
Settings)
The last saving was not successful (Error: Last Save)
20000 - The value presented on the display is twenty-
thousand
-20000 The value presented on the display is minus
twenty-thousand
Code? (Code)
Bad Code (Bad Code)
A User login took place (User)
A Supervisor login took place (Supervisor)
The typed number is lower than allowed (Low Limit)
The typed number is higher than allowed (High Limit)
Low numeric value not possible to display
High numeric value not possible to display
Re-type it please (Re-type)
Automatic escaping (Auto Escape) — after 1 minute
Exit from the setting (Exit)
23