Display Operating Modes (12. Menu Item) - Datcon DT9000 Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by typing a supervisor code.
56

7.14. Display operating modes (12. menu item)

The instrument has a 4-and-a-half-digit display. It is
possible to switch it into a 3-and-a-half-digit display mode.
In this case the display behaves like a 3-and-a-half-digit
display during measurement. (The mnemonics are
displayed in four digits).
[Default factory setting: four-and-a-half-digit operating
mode.]
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.

4. You see this
blinking.
5. You may switch between the two operating modes by
pressing ▲ button.

•
 = four-and-a-half-digit operating mode [Default
factory setting]

•
 = three-and-a-half-digit operating mode
In the three-and-a-half-digit operating mode the possible
range of numbers to display is reduced to the values being
between -2000 and 2000.

.
on the display. The mnemonic is
DT9000

.
20171205-V2