Disable Displaying The Leader Zeros (13. Menu Item) - Datcon DT9000 Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by typing a supervisor code.
58
7.15. Disable displaying the leader zeros
(13. menu item)
Leader zero: the zeros that stand before an integer of no
value. E.g. the instrument displays the value 5.2 together
with the leader zeros:

(default factory setting), or without the leader

zeros: .
In this menu item you can either disable displaying of the
leader zeros, or you can enable this function again.
The way the code should be type is described in Chapter
7.1. Typing the code in. You see on the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.

4. You see this
5. You may switch between the two operating modes by
pressing ▲ button.

•
 = the leader zeros are shown on the display
(default factory setting).

•
 = the leader zeros are not shown on the display.
Comment: one zero directly before the decimal point is
always shown on the display.

.
on the display. The text is blinking.
DT9000

.
20171205-V2