Table of Contents
Advertisement
DT9000
High limit value
Sequence of operations
20171205-V2
Setting the high limit value and It's hysteresis is necessary
in that case only, if you had selected the
operating mode.
23. Pressing the ▲ button keep stepping as long as you
see this sub-menu item:
the high limit value. Here you can define the higher
numerical value, to which the instrument compares the
measured physical values.
24. Enter by pressing the ENTER button.
25. You see this
is blinking in the upper left corner. The arrow indicates that
the uppermost digit (the „half" digit) is being selected from
the 4 and half digits, and now it can be modified by
pressing the ▲ button.
26. Pressing the ▲ button you can switch the „half" digit on
or off, or you can type in the value 20.000.
•
= 10.000;
•
= 0.000
27. Pressing the ► button you can select the next digit.
28. Pressing the ▲ button you can increase the value of
the blinking digit:
,
,
,
,
29. When the last digit (right-side) is being selected, and
you press the ► button, a blinking colon appears on the
left side:
plus/minus sign is being selected, and it can be modified by
pressing the ▲ button.
30. Pressing the ▲ button you can switch the minus sign
on or off.
•
= 10.000;
31. After you have set the value for the limit, press the
MENU button to exit from the sub-menu item, and you see
this:
.
32. L1.HL must not be lower than L1.LL. Should the case
be this, the instrument call attention you by a blinking
mnemonic
lowest permissible value.
. HL (High Limit) means:
on the display, and the arrow (
•
= 20.000
,
,
,
,
,
. The colon indicates that the
•
, and exchanges the wrong value to the
or the
←
, etc.
= -10.000
)
37
Advertisement
Table of Contents
