Installing The Server Into A Rack - Oracle X5-2 Installation Manual

Installing the Server Into a Rack

This section describes how to install the server into a rack using the rail assembly in the
rackmount kit. Perform these procedures if you purchased the rail assembly.
In this guide, the term "rack" means either an open rack or a closed cabinet.
Note -
Description
Complete all installation prerequisite tasks.
Check that your rack meets the requirements
for installation of this server.
Review safety precautions.
Verify that you have received all components
of the rackmount kit.
Stabilize the rack.
Install mounting brackets onto the server.
Mark the rackmount location.
Connect AC power cables in the Sun Rack II
1042.
Attach the tool-less slide-rail assembly to the
rack.
Install the server into the slide-rail assembly.
(Optional) Install the cable management arm
for routing server cables.
(Optional) Install the Shipping Bracket With
Cable Trough for shipping the server in a rack.
Related Information
"Installation Procedure" on page 13
■
"Preparing for Server Installation" on page 15
■
Links
"Installation Prerequisites" on page 40
"Rack Requirements" on page 40
"Safety Precautions" on page 41
"Rackmount Kit Contents" on page 42
"Stabilize the Rack for Installation" on page 43
"Install Mounting Brackets On the Server " on page 44
"Mark the Rackmount Location" on page 45
"Connect AC Power Cables Before Installing Tool-less Slide-Rails
in Sun Rack II 1042" on page 47
"Attach Tool-less Slide-Rail Assemblies" on page 49
"Install the Server Into the Slide-Rail Assemblies" on page 52
■ "Install the Cable Management Arm" on page 58
■ "Remove the Cable Management Arm" on page 70
"Install the Shipping Bracket With Cable Trough
(Optional)" on page 54
Installing the Server Into a Rack 39