Oracle Exadata Storage Server X6-2 High Capacity Installation Manual page 53

a. Simultaneously pull and hold the two green release tabs (one on each side
of of the storage server) toward the front of the storage server while you
push the storage server into the rack. As you push the storage server into
the rack, verify that the CMA retracts without binding.
To pull the green release tab, place your finger in the center of the tab, not on the end,
Note -
and apply pressure as you pull the tab toward the front of the storage server.
b. Continue pushing the storage server into the rack until the slide-rail locks
(on the front of the storage server) engage the slide-rail assemblies.
You will hear an audible click when the storage server is in the normal rack position.
6. Adjust the cable straps and the CMA, as required.
Related Information
"Install the Storage Server Into the Slide-Rail Assemblies" on page 38
■
"Install the Cable Management Arm" on page 40
■
Verify Operation of Slide-Rails and Cable Management Arm
Installing the Storage Server Into a Rack 53