Remove The Cable Management Arm - Oracle Exadata Storage Server X6-2 High Capacity Installation Manual

Remove the Cable Management Arm

Remove the Cable Management Arm
Follow this procedure to remove the cable management arm (CMA).
Before you begin this procedure, refer to
and identify CMA connectors A, B, C, and D. You should disconnect the CMA connectors in
the reverse order in which you installed them, that is, disconnect connector D first, then C, then
B, and finally A.
Throughout this procedure, once you disconnect any of the CMA's four connectors, do not
allow the CMA to hang under its own weight.
Note -
the equipment rack.
1. To prevent the rack from tipping forward when the storage server is extended,
extend all rack anti-tilt devices.
Caution -
devices before extending the storage server from the rack. For instructions for stabilizing the
rack, see
Disconnect all cables from the rear of the storage server.
2.
Extend the storage server approximately 13 cm (5 inches) out of the front of the
3.
rack.
4. To remove the cables from the CMA:
If applicable, remove any additional Velcro straps that were installed to
a.
bundle the cables.
Unwrap the six Velcro straps that are securing the cables.
b.
c. Open the three cable covers to the fully opened position.
d. Remove the cables from the CMA and set them aside.
5. To disconnect connector D:
54 Oracle Exadata Storage Server X6-2 High Capacity Installation Guide • July 2018
References to "left" or "right" in this procedure assume that you are facing the back of
To reduce the risk of personal injury, stabilize the rack cabinet and extend all anti-tilt
"Stabilize the Rack for Installation" on page
"Install the Cable Management Arm" on page 40
29.