Calibration; Procedure - Rice Lake SCT-2200 Advanced Series Technical Manual

5.0

Calibration

The type of calibration used is dependent on the type of application chosen for the instrument.
5.1

Procedure

Use this procedure to calibrate the scale in either the  or the  mode. Each individual cell must be
connected to an instrument channel. To connect more than four cells, it is necessary to trim the cells.
1. Turn on the instrument and press
2.
until  displays. Press
Press or
3.
Press or until  displays. Press
4.
Press or until  displays. Press
5.
Press to enter the menu.
6.
Press or to
7. Press to confirm selection.
Note
By setting the divisions of the first range, the unit automatically sets the divisions of the second range.
8.
Press to enter the menu.
9.
Press or to
displays.
10.
Press to enter the menu.
11.
Press or to
range. Press
12.
Press to enter the menu.
Set the total capacity of the scale, or  if using multi-range functioning,
13.
digit to be modified and
on page 15 for more information on multi-range functioning.
14. For dual range scale only:
second range
using
to confirm.  displays.
Press

The is disabled if set at 000000. See
Note
functioning.
15.
Press to enter the menu.  displays.
16.
Press to enter the menu.
17. Set the desired number (1-3) of calibration points with the
displays. Press
18. Unload the scale and wait until
19. Set the weight value of first sample weight
increase or decrease the digit. Press
20.
Press or until  displays and press
21. Put the weight on the scale, wait a few seconds, and press
complete and a calibration point is set, the internal divisions value momentarily displays followed
by .
44 SCT-2200 Weight Transmitter
while the firmware version displays.  displays.
set the decimal place value (, , , ).
 displays.
set the unit of measure (,,,). Press
set the scale's minimum division (1, 2, 5, 10, 20, 50), or the first range of dual
to confirm value
 displays.
.
or to increase or decrease the digit. Press
Press or
to select the digit to be modified and
.
 displays. Press
to confirm.
to enter the menu.
to enter the menu.
to enter the menu.  displays.
until  displays. Press
or
Section 3.3 on page 15 for more information on multi-range
or
.
using to select the digit to be modified and
.
.
to confirm selection.
using to select the
to confirm. See
to enter the menu.
to increase or decrease the digit.
keys and press
Once the weight acquisition is

Section 3.3
Set the
.

or to