Unit Of Measure Conversion; Net Weight/Gross Weight Conversion; Input/Output Weighing - Rice Lake SCT-2200 Advanced Series Technical Manual

3.8.1 Unit of Measure Conversion

This function toggles the displayed weight between the scale unit of measure and lb.
• Press to toggle between the scale unit of measure.
• Long press to enter the setpoint input menu. See
All scales connected to the instrument must have the same unit of measure to toggle between scales.
Note
The conversion takes place for any unit of measure set during the calibration.

3.8.2 Net Weight/Gross Weight Conversion

This function toggles the display between net weight and gross weight.
• Press to toggle between net weight and gross weight.
• Long press to enter the setpoint input menu. See

3.8.3 Input/Output Weighing

Through operator confirmation, the instrument acquires two weights and calculates the difference. The data is then
printed if a printer has been configured.
To Set Input/Output Weighing Mode
1. Select the mode.  displays momentarily.
2. Select one of the print settings from
3. Press to confirm.
Setting
Printed data includes:
 (gross/tare)
Printed data includes:


(first weigh/second weigh)
Printed data includes:
 (input/output)
To Use Input/Output Weighing Mode
1. Press to acquire first weight.  displays.
again to acquire second weight.  displays. Data prints after acquisition of the second
2. Press
weight.
Press and hold
Note
The weighing cycle can be interrupted by pressing
Press to confirm the cancellation or another key to continue.
A weight is acquired when:
* The weight is stable and greater than zero
I

* The
Table 3-2
• GROSS – gross weight and the unit of measure
• TARE – tare weight and the unit of measure
• NET – difference between the gross and tare weights and the unit of measure
• WEIGH 1 – first weight and the unit of measure
• WEIGH 2 – second weight and the unit of measure
• NET – difference (without sign) between WEIGH 1 and WEIGH 2 and the unit of measure
• INPUT – first weight and the unit of measure
• OUTPUT – second weight and the unit of measure
• NET – zero weight and unit of measure if WEIGH 1 = WEIGH 2
• INPUT NET – difference (without sign) between INPUT and OUTPUT and unit of measure if WEIGH
1 is greater than WEIGH 2
• OUTPUT NET – difference (without sign) between INPUT and OUTPUT and unit of measure if
WEIGH 1is less than WEIGH 2
Table 3-2. Input/Output Weigh Mode Settings
to enter the setpoint input menu . See
parameter conditions have been met. See
Section 4.3 on page 41.
Section 4.3 on page 41.
Description
Section 4.3 on page
C
after the acquisition of the first weight.
Table 4-3 on page 33
41.

displays.
.
Operation 19