Calibration; Calibrate With Pad Display; Complete Calibration Procedure - Rice Lake Load Ranger Series Technical Manual

Load Ranger Wheel Weigh Pad System
5.0

Calibration

This section provides the procedures necessary to calibrate the Load Ranger wheel weigh pads through the built-in displays
and with the Ai-1 indicator.
When using the Ai-1 indicator with the weigh pads, skip to
through the Ai-1 indicator.
Note
5.1

Calibrate with Pad Display

This section describes procedures for setting calibration parameters and the calibration of the Load Ranger Wheel Weigh Pads
through the built-in display.
5.1.1

Complete Calibration Procedure

Follow these steps to set the calibration parameters and complete a calibration:
Press at any time to back out one level or multiple times to return to the weigh mode.
Note
1. Turn indicator on by pressing
2. Press .  displays.
If displays instead of

Note
displays. Now continue with

3. Press .  displays.
4. Press . The current decimal setting displays.
5. Press to scroll through decimal settings and press
6. Press . The current division setting displays.
7. Press to scroll through division settings and press
8. Press . The current unit setting displays.
9. Press to scroll through unit settings and press
10. Press . Range 1 value displays. Use the numeric entry procedure to set value.
For single-range scales, Range 1 is set as the max scale capacity.
Note
11. Press .  displays.
Range 2 should only be set for multi-range scales. For single-range scales, skip to
Note
12. Press . Range 2 value displays. Use the numeric entry procedure to set value.
13. Press .  displays.
14. Press .  displays.
15. Press .  displays. Make sure weigh pad is unloaded.
16. Press .  briefly displays once the procedure is complete, then  displays.
17. Press . The current setting for the number of calibration points displays.
18. Press to scroll through settings (1-3) and press
19. Use the numeric entry procedure to set the calibration weight value and press
34 Visit our website
and press during startup.  displays.
, press , then press

Step 3.
www.RiceLake.com
Section 5.2 on page 35
two times until

to save selection.  displays.
to save selection.  displays.
to save selection.  displays.
to save selection. Calibration point 1 value displays.
.  displays.
to calibrate all of the weigh pads
displays. Press and
Step 14.