7.4 Pairing with Receiver RX10RF
PLEASE NOTE!
For easier installation, please make sure you have already added RX10RF receiver to your ZigBee network (please refer to the RX10RF receiver manual
instruction).
1
Select "YES" by „
buttons. Confirm by
4
Press
button for 3 seconds to expand
"SYSTEM TYPE" menu.
7
5 sec.
5 sec.
Close the ZigBee network
54
2
" or „
"
button.
5
Use
- choose pairing with the RX10RF receiver in the
„RX1" configuration, if the receiver is set as RX1
(receiver responds to the heating signal from any
thermostat),
- choose pairing with the RX10RF receiver in the
„RX2" configuration, if the receiver is set as RX2
(receiver responds to the heating signal from only
one thermostat).
3
Confirm by
OR
3
Now thermostat is looking for the
signal from the coordinator...
or
buttons to:
button
3
5 sec.
OR
5 sec.
Open the ZigBee network
6
After all you will see the main
thermostat's display.