Table of Contents
Advertisement
VERSION 11/2015
OPERATING MANUAL
8.1.3
DECOMMISSIONING AND CLEANING
The device should be cleaned for maintenance purposes. Ensure that no remaining
product dries on and sticks to the device.
1. Carry out work interruption
2. Carry out basic fl ushing
3. Empty the pump in a controlled manner
4. Maintain the gun according to the operating manual.
5. Clean and check the suction system and the suction fi lter.
6. Clean the outside of the system.
Brittle fi lter pressure regulator!
The tank on the fi lter pressure regulator becomes brittle through
contact with solvents and can burst.
Flying parts can cause injury.
7. Fully assemble the system.
8. Check fi ll level of the separating agent
9. Fill the system with fl ushing agent in accordance with Chapter 8.2.6.
Gas mixtures can explode if there is an incompletely filled
pump!
Danger to life from fl ying parts.
8.1.4
LONG-TERM STORAGE
When storing the device for longer periods of time, it is necessary to thoroughly clean it
and protect it from corrosion. Replace the water or solvent in the product pump with a
suitable preservative, fi ll separating agent cup with separating agent.
Procedure:
1. Chapter 8.1.3 "Decommissioning and Cleaning", perform points 1 to 7.
2. Fill the system with preservative in accordance with Chapter 8.2.6.
3. Empty the pump in a controlled manner in accordance with Chapter 8.2.5 and seal
the openings.
ORDER NUMBER DOC2333553
Chapter 7.5.
in accordance with Chapter 7.6.
WARNING
Do not clean the tank on the fi lter pressure regulator with
solvent.
Chapter 8.2.4.
WARNING
Ensure that the pump and suction system are always completely
filled with fl ushing agent or working medium.
Do not spray the device empty after cleaning.
in accordance with Chapter 8.2.5.
43
Advertisement
Table of Contents
