Filling The Empty Pump - WAGNER EvoMotion 20-30 Operating Manual

VERSION 11/2015
OPERATING MANUAL
8.2.6

FILLING THE EMPTY PUMP

Note:
Before each fi lling, the nozzle must be removed from the gun. The data in the gun's
operating manual are to be observed.
In case of AirCoat systems, carry out the fi lling of the system without atomizing air (8).
1. Place empty tank (5) under return tube (4).
2. Place suction hose (7) in the tank with working material (6).
3. Open return valve (3).
4. Slowly open the ball valve (2).
5. Adjust the air pressure on the pressure regulator (1) so that the pump runs
smoothly.
6. Spray until clean working material fl ows into the tank (5).
7. Close ball valve (2).
8. Close return valve (3).
9. Point the gun (9), without nozzle, into tank (5) and open it.
10. Slowly open the ball valve (2).
11. Spray until clean working material fl ows from the gun (9).
12. Close ball valve (2).
13. Relieve the system pressure, either by opening the return valve (3) or via the trigger
on the gun (9).
14. When there is no pressure remaining in the system, close the gun (9) or the return
valve (3).
15. Secure the gun.
16. Dispose of the contents of the tank (5) according to the local regulations.
ORDER NUMBER DOC2333553
48