Table of Contents
Advertisement
VERSION 11/2015
OPERATING MANUAL
7
OPERATION
7.1
TRAINING THE OPERATING STAFF
The operating staff must be qualifi ed and fi t to operate the entire system.
The operating staff must be familiar with the potential risks associated with improper
behavior as well as the necessary protective devices and measures.
Before work commences, the operating staff must receive appropriate system training.
7.2
SAFETY INSTRUCTIONS
Before carrying out any work, the following points must be observed in accordance with
the operating manual:
Observe all safety regulations in accordance with Chapter 4.
Carry out commissioning in accordance with Chapter 6.6.
Incorrect operation!
Risk of injury and damage to the device.
Unintentional putting into operation!
Risk of injury
Before any work on the device, in the event of work interruptions
and malfunctions:
ORDER NUMBER DOC2333553
WARNING
If contact with lacquers or cleaning agents causes skin irritation,
appropriate precautionary measures must be taken, e.g.,
wearing protective clothing.
The footwear worn by operating staff must comply with
EN ISO 20344. The measured insulation resistance must not
exceed 100 megohms.
The protective clothing, including gloves, must comply with
EN ISO 1149-5. The measured insulation resistance must not
exceed 100 megohms.
WARNING
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
Switch off the energy/compressed air supply.
Disconnect the control unit form the network.
In the event of functional faults: remedy the fault as described in
the "Troubleshooting" chapter.
34
Advertisement
Table of Contents
