Removal - NEC Express5800 Series User Manual

Chapter 2 Preparations
Color
Orange
Blue
Yellow
・Power Cable
6. Data cable for RAID Controller is connected under below configuration.
・When connecting to RAID Controller (PCIboard Type-p)
See Chapter 2 (1.12 RAID Controller (PCIboard Type-p)) to connect.
・When connecting to RAID Controller (AROC Type-a)
See Chapter 2 (1.13 RAID Controller N8103-189/190 (AROC Type-a)) to connect.
・When connecting to 12G SAS Expander Card
See Chapter 2 (1.14 SAS Expander Card N8116-84) to connect.
7. See Chapter 2 (1.6 Air Baffle) to attach the air baffle.
8. See Chapter 2 (1.5 Top Cover) to attach the top cover to the system.
9. Please see Chapter 2 (2. Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
1.22.2

Removal

The procedure for removal is the reverse of installation.
Re-attach the blank cover if you operate without it attached.
134
Rear 2-bay SFF drive backplane to SATA port 5
Rear 2-bay SFF drive backplane to SATA port 4
Rear 2-bay SFF drive backplane to SATA management port
Note
In order to prevent damage of the system due to improper cooling or elevated temperature,
please do not activate the server or enclosure without implementing any of component or
blank on all of drive bays and device bays.
Important
Re-attach the blank cover removed to maintain the internal cooling.
Express5800/R120h-2E User's Guide
1. Installing Internal Optional Devices
Description