NEC Express5800 Series User Manual page 175

Chapter 3 Setup
Category
Use Wake on LAN
Boot
(WOL)
Enable X2APIC
Boot
feature
your OS.
Security Set a password
Restrict bootup by
entering password
Description
Set enable or disable of (a) and (b) below.
When using the built-in network controller,
the setting in (b) is not reflected.
(a) System Configuration > (Network
device) > NIC Configuration - Wake On
LAN
(b) System Configuration > BIOS/Platform
Configuration (RBSU) > System Options >
Server Availability - Wake-On LAN
When performing WOL from OS shutdown,
set the followings since the setting OS of (a)
has a priority.
Windows OS:
Device Manager > Device used for WOL
under the network adapter > Advanced –
Set Enable PME to Enable. Set it to Disable
to disable WOL.
Advanced > Processor Configuration >
according to
X2APIC > Disabled *1
・Disable X2APIC for the following OS.
－ Windows Server 2012 R2
－ Windows Server 2016
－ VMware ESXi6.0u3
－ VMware ESXi6.5u1
Set your password in System Configuration >
BIOS/Platform
Server Security - Set Admin Password
Set your password in System Configuration >
BIOS/PlatformConfiguration
Server Security
Password
Express5800/R120h-2E User's Guide
To be changed
Configuration (RBSU) >
(RBSU) >
using Set Power On
2. Description on System Utility
(3/4)
Remark
For the WOL support for
the optional network card,
refer to the user's guide for
optional card.
the
The setting must be done
in compliance with the
checklist before setup in
the installation guide of
your OS
For Windows: [Chapter 1
Installing Windows]
If you set your password,
your are prompted to enter
the password from the
next time you start System
Utility
If you set your password,
your are prompted to enter
the password from the
next time you start the
system
175