Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 319

Port Show Commands
===========================================================================
Internal Loopback Port Status
===========================================================================
Port
Id
---------------------------------------------------------------------------
1/1/3
2/1/3
3/1/3
4/1/3
========================================
Mac-swap Application Status
========================================
Enabled
Test Service Id
Test Sap Id
========================================
===========================================================================
*A:7210SAS>show>system#
Mac-swap Application Status — The following table describes Mac-swap Application Status
associations output fields.
LoopBack Type
Application
Service enabled
Enabled
Test Service Id
Test Sap Id
Loopback Src
Addr
Loopback Dst
Addr
Page 314
Guide
Loopback Application
Type
Virtual Not-In-Use
Virtual Not-In-Use
Virtual Not-In-Use
Virtual Not-In-Use
: No
: None
: None
Label
The Loopback type indicates whether the port is in Physical Front
panel port or Internal Virtual port.
Application mentions the application in use of the port.
The Service enabled displays, if services can be configured over this
port.
Displays the current status.
The service ID that is used in the configuration of Mac-swap test.
The SAP ID that is used to configure the loopback SAP for the Mac-
swap application.
The source MAC address that is used in the configuration of port
loopback mac-swap test.
The destination MAC address that is used in the configuration of port
loopback mac-swap test.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Service Speed Type
Enabled 1G/10G
No 1G
No 1G
No 1G
No 1G
Description