Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 18

Configuration Overview
A:7210SAST>show# card
===============================================================================
Card Summary
===============================================================================
Slot
-------------------------------------------------------------------------------
1
A
===============================================================================
A:7210SAST>show#
Sample output for 7210 SAS-Mxp:
*A:sim_dutc>show# card state
===============================================================================
Card State
===============================================================================
Slot/
Id
-------------------------------------------------------------------------------
1
1/1
A
===============================================================================
*A:sim_dutc>show#
The 7210 SAS-R6 is a chassis based platform with 6 IMM slots and 2 CPM slots. On a chassis
based platform the slots must be provisioned. To pre-provision a chassis slot, the line card type
must be specified. System administrators or network operators can enter card type information for
each slot, allowing a range of card types in particular slots. From the range of card types, a card
and accompanying MDAs (if any) are specified. When a card is installed in a slot and enabled, the
system verifies that the installed card type matches the allowed card type. If the parameters do not
match, the card remains offline. A pre-provisioned slot can remain empty without conflicting with
populated slots. 7210 SAS-R6 supports only CPM and IMMs. It does not support any physical
removable MDAs. Software uses logical MDAs internally to represent the ports on the IMMs and
the MDA type is auto-provisioned by software when the IMMs are provisioned. Please check the
latest release notes for a list of supported card types (that is, CPM and IMMs). For more
information on installation of cards, see the 7210 SAS-R6 Installation Guides.
The 7210 SAS-R12 is a chassis based platform with 12 IMM slots and 2 CPM slots. On a chassis
based platform the slots must be provisioned. To pre-provision a chassis slot, the line card type
must be specified. System administrators or network operators can enter card type information for
each slot, allowing a range of card types in particular slots. From the range of card types, a card
and accompanying MDAs (if any) are specified. When a card is installed in a slot and enabled, the
system verifies that the installed card type matches the allowed card type. If the parameters do not
match, the card remains offline. A pre-provisioned slot can remain empty without conflicting with
Page 12
ration Guide
Provisioned Type
Equipped Type (if different)
iom-sas
sfm-sas
Provisioned Type
Equipped Type (if different)
iom-sas
m22-sfp+2-tx+4-sfpp
sfm-sas
Admin Operational
State State
up
up
Admin Operational
State State
up up
up up
up up
7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
Comments
up
up/active
Num Num Comments
Ports MDA
2
24
Active