Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 249

Hardware Commands
Parameters
mda-id[/port] — Displays the pool information of the specified MDA.
access-app pool-name — Displays the pool information of the specified QoS policy.
Values
network-app pool-name — Displays the pool information of the specified QoS policy.
Values
Output Show Pool Output — The following table describes show pool output fields.
Type
ID
Application/Type
Pool Name
Resv CBS
Utilization
State
Start-AvgThresh-
old
Max-Avg
Time Avg Factor
Actual ResvCBS
Admin ResvCBS
PoolSize
Pool Total
Pool Shared
Pool Resv
Page 244
Guide
access-ingress, access-egress
network-egress
Label
Specifies the pool type.
Specifies the card/mda or card/MDA/port designation.
Specifies the nature of usage the pool would be used for. The pools
could be used for access or network traffic at either ingress or egress.
Specifies the name of the pool being used.
Specifies the percentage of pool size reserved for CBS.
Specifies the type of the slope policy.
The administrative status of the port.
Specifies the percentage of the buffer utilized after which the drop
probability starts to rise above 0.
Specifies the percentage of the buffer utilized after which the drop
probability is 100 percent. This implies that all packets beyond this
point will be dropped.
Specifies the time average factor the weighting between the previous
shared buffer average utilization result and the new shared buffer utili-
zation in determining the new shared buffer average utilization.
Specifies the actual percentage of pool size reserved for CBS.
Specifies the percentage of pool size reserved for CBS.
Specifies the size in percentage of buffer space. The value '-1' implies
that the pool size should be computed as per fair weighting between all
other pools.
Displays the total pool size.
Displays the amount of the pool which is shared.
Specifies the percentage of reserved pool size.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Description