Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 202
Service access switch
Hide thumbs
Also See for 7210 SAS M:
- Service manual (952 pages) ,
- Configuration manual (558 pages) ,
- Quality of service manual (404 pages)
Table of Contents
Advertisement
standby-signalling
Syntax
standby-signalling {lacp | power-off}
no standby-signalling
Context
config>lag
Description
This command specifies how the state of a member port is signalled to the remote side when the status
corresponding to this member port has the standby value.
Default
lacp
Parameters
lacp — Specifies that LACP protocol is used to signal standby links of the LAG.
power-off — The laser of the standby links in the LAG are shutoff to indicate "standby" status. It allows
user to use LAG standby link feature without LACP, if the peer node does not support LACP.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
Interface Configuration
Page 197
Advertisement
Table of Contents
