Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 305

Port Show Commands
===============================================================================
-------------------------------------------------------------------------------
Unicast Packets
Multicast Packets
Broadcast Packets
Discards
Unknown Proto Discards
===============================================================================
===============================================================================
Ethernet-like Medium Statistics
===============================================================================
Alignment Errors :
FCS Errors
SQE Test Errors
CSE
Too long Frames
Symbol Errors
===============================================================================
A:7210-SAS-X>show#
Port ACR Detail Output — The following table describes ACR detail output fields.
Clock Master PW
Clock Sync State
Endpoint
Bit-rate
Payload Size
Jitter Buffer
Use RTP Header
CAS Framing
Effective PDVT
Cfg Alarm
Alarm Status
Page 300
Guide
:
:
:
:
:
Label
The SAP being used by the port for recovering the clock.
The current state of the ACR adaptive algorithm.
The type of endpoint.
The number of DS0s or timeslots in the channel group.
The number of octets contained in the payload of a TDM PW packet
when the packet is transmitted.
The size of the receive jitter buffer, expressed in milliseconds.
Whether RTP headers are used in CES packets (Yes or No).
The type of CAS framing.
The peak-to-peak packet delay variation (PDV) used by the circuit
emulation service. Since the operating system may adjust the jitter
buffer setting in order to ensure no packet loss, the configured jitter
buffer value may not be the value used by the system. The effective
PDVT provides an indication that the PDV has been adjusted by the
operating system.
The alarms that have alarm reporting enabled.
The current alarm state (for example, stray, malformed, packet loss,
overrun, underrun, remote packet loss, remote fault, or remote RDI).
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Input
0
0
5415
0
0
0 Sngl Collisions :
0 Mult Collisions :
0 Late Collisions :
0 Excess Collisns :
0 Int MAC Tx Errs :
0 Int MAC Rx Errs :
Description
Output
0
0
0
0
0
0
0
0
0
0