Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 195

TDM Commands (Applicable to 7210 SAS-M when using the CES MDA)
This limitation does not apply to Serial Data Interface card and E&M card traffic transported over MPLS as
the signaling is transported in individual pseudowires.
Parameters cas — Specifies channel associated signaling.
timeslots
Syntax timeslots timeslots
no timeslots
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the list of DS-0 timeslots to be used in the DS-1 or E-1 channel-group. The timeslots
need not be consecutive.
The no form of this command removes DS-0 timeslots from a channel group.
Default
no timeslots — Non-ATM channel groups.
Parameters
timeslots — Specifies the timeslot(s) to be associated with the channel group. The value can consist of a list
of timeslots. Each member of the list can either be a single timeslot or a range of timeslots.
Values
Page 190
Guide
1 — 24 for DS-1 interfaces
2 — 32 for E-1 interfaces
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration