Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 298

Fragments
Jabbers
Octets
Packets
Unicast packets
input/output
Multicast pack-
ets input/output
Broadcast pack-
ets input/output
Discards input/
output
Unknown proto
discards input/
output
Unknown proto
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
Label
The total number of packets received that were shorter than 64 octets
(excluding framing bits but including FCS octets) that had either a bad
Frame Check Sequence (FCS) with an integral number of octets (FCS
Error) or a bad FCS with a non-integral number of octets (Alignment
Error).
The total number of packets received that were longer than 1518 octets
(excluding framing bits but including FCS octets) that had either a bad
Frame Check Sequence (FCS) with an integral number of octets (FCS
Error) or a bad FCS with a non-integral number of octets (Alignment
Error).
Total number of octets received.
The number of packets received, broken down by size Port Statistics.
The number of packets, delivered by this sub-layer to a higher (sub-)
layer, which were not addressed to a multicast or broadcast address at
this sub-layer. The total number of packets that higher-level protocols
requested be transmitted, and which were not addressed to a multicast
or broadcast address at this sub-layer, including those that were dis-
carded or not sent.
The number of packets, delivered by this sub-layer to a higher (sub-)
layer, which were not addressed to a unicast or broadcast address at
this sub-layer. The total number of packets that higher-level protocols
requested be transmitted, and which were not addressed to a unicast or
broadcast address at this sub-layer,including those that were discarded
or not sent.
The number of packets, delivered by this sub-layer to a higher (sub-)
layer,which were not addressed to a unicast or multicast address at this
sub-layer. The total number of packets that higher-level protocols
requested be transmitted, and which were not addressed to a unicast or
multicast address at this sub-layer, including those that were discarded
or not sent.
The number of inbound packets chosen to be discarded to possibly free
up buffer space.
For packet-oriented interfaces, the number of packets received via the
interface that were discarded because of an unknown or unsupported
protocol. For character-oriented or fixed-length interfaces that support
protocol multiplexing, the number of transmission units received via
the interface that were discarded because of an unknown or unsup-
ported protocol. For any interface that does not support protocol multi-
plexing, this counter will always be 0.
Discards do not show up in the packet counts.
Interface Configuration
Description
Page 293