Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 301

Port Show Commands
Loopback Time Left
Configured
Address
Hardware Address
Traffic Statis-
tics
Ethernet Statis-
tics
A:7210>show# port A/1
===============================================================================
Ethernet Interface
===============================================================================
Description
Interface
Link-level
Admin State
Oper State
Physical Link
Single Fiber Mode
IfIndex
Page 296
Guide
Label
The number of seconds left in a timed loopback If there is no loopback
configured or the configured loopback is latched, the value is
unspecified.
The base chassis Ethernet MAC address.
The interface's hardware or system assigned MAC address at its
protocol sub-layer.
Octets input/output – the total number of octets received and
transmitted on the port Packets input/output – the number of packets,
delivered by this sub-layer to a higher (sub-) layer, which were not
addressed to a multicast or broadcast address at this sublayer. The total
number of packets that higher-level protocols requested be transmitted,
and which were not addressed to a multicast or broadcast address at
this sub-layer, including those that were discarded or not sent.
Errors input/output – for packet-oriented interfaces, the number of
inbound packets that contained errors preventing them from being
deliverable to a higher-layer protocol. For character-oriented or fixed-
length interfaces, the number of inbound transmission units that
contained errors preventing them from being deliverable to a higher-
layer protocol.
For packet-oriented interfaces, the number of outbound packets that
could not be transmitted because of errors. For character-oriented or
fixed length interfaces, the number of outbound transmission units that
could not be transmitted because of errors.
Broadcast Pckts — the number of packets, delivered by this sub-layer
to a higher (sub-) layer, which were not addressed to a unicast or
multicast address at this sub-layer. The total number of packets that
higher-level protocols requested be transmitted, and which were not
addressed to a unicast or multicast address at this sub-layer, including
those that were discarded or not sent.
: 10/100 Ethernet TX
: A/1
: Ethernet
: up
: up
: Yes
: No
: 67141632
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Description (Continued)
Oper Speed
Config Speed
Oper Duplex
Config Duplex
MTU
Hold time up
: 10 mbps
: 100 mbps
: half
: full
: 1514
: 0 seconds