Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 138

port — The default state for a port is shutdown.
path — The default state for a SONET/SDH path is shutdown.
card
Syntax card slot-number
Context config
Description
This mandatory command enables access to the chassis card Input/Output Module (IOM), slot, and MDA
CLI context.
The no form of this command cannot be used on fixed IOM and MDA cards that are auto equipped and auto
provisioned.
Default The IOM card is equipped and provisioned for slot 1.
Parameters slot-number — The slot number of the card in the chassis.
card-type
Syntax card-type card-type
Context config>card
Description This mandatory command adds a to the device configuration for the slot. The card type can be
preprovisioned, meaning that the card does not need to be installed in the chassis.
A card must be provisioned before an MDA or port can be configured.
A card can only be provisioned in a slot that is vacant, meaning no other card can be provisioned
(configured) for that particular slot.
A card can only be provisioned in a slot if the card type is allowed in the slot. An error message is generated
if an attempt is made to provision a card type that is not allowed.
A high severity alarm is raised if an administratively enabled card is removed from the chassis. The alarm is
cleared when the correct card type is installed or the configuration is modified. A low severity trap is issued
when a card is removed that is administratively disabled.
An appropriate alarm is raised if a partial or complete card failure is detected. The alarm is cleared when the
error condition ceases.
NOTE: This command is not required for 7210 SAS-X, 7210 SAS-M, 7210 SAS-T, and 7210 SAS-Mxp
devices as the cards are pre-provisioned.
The no form of this command cannot be used as the IOM card is fixed.
Default
The IOM card is equipped and preprovisioned for slot 1.
Parameters
card-type — The type of card to be configured and installed in that slot.
Values
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
7210 SAS-M and 7210 SAS-Mxp - iom-sas
Interface Configuration
Page 133