Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 175

Ethernet Port Commands
9. Disable loop back and execute the command config >port>ethernet> no loopback internal.
10. Enable the port and execute the command config>port> no shutdown.
11. Enable the required services.
Parameters service <service-id> — The unique service identification number or string identifying the service in the
service domain. This ID must be unique to this service and may not be used for any other service of any
type. The service-id must be the same number used for every on which this service is defined.
Values
sap <sap-id> — Specifies the physical port identifier portion of the SAP.
Values
Values
src-mac <SA> — Specifies the source MAC address.
Values
dst-mac <DA> — Specifies the destination MAC address.
Values
ssm
Syntax ssm
Context config>port>ethernet
Description
This command enables Ethernet Synchronous Status Message (SSM).
code-type
Syntax code-type [sonet | sdh]
Context config>port>ethernet>ssm
Description
This command configures the encoding of synchronous status messages, that is, to select either SDH or
SONET set of values. Configuring the code-type is only applicable to Synchronous Ethernet ports. It is not
configurable on TDM ports. For the code-type, SDH refers to ITU-T G.781 Option-1,while SONET refers to
G.781 Option 2 (equivalent to Telcordia GR-253-CORE).
Default sdh
Page 170
Guide
service-id 1 — 2147483648
sap-id null - <port-id>
dot1q - <port-id>:qtag1
qinq - <port-id>:qtag1.qtag2
port-id - slot/mda/port[.channel]
id - [1..1000]
qtag1 - [0..4094]
qtag2 - [*|1..4094]
SA 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx).
DA 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx).
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration