Free-Standing And Desktop Mounting Of Multiple Switches; Removing A Summit Switch From A Rack (Ac Units Only); Installing And Removing Summit Dc-Powered Switches - Extreme Networks Summit X450a-24tDC Hardware Installation Manual

Installing Summit Family Switches
8 Connect the power cables.
For AC-powered units, connect the power cable to the AC power connector on the back of the
●
switch. Then connect the power cable to an AC power socket.
For information about DC-powered units, see
●
Switches" on page

Free-Standing and Desktop Mounting of Multiple Switches

Summit family switches are supplied with four self-adhesive rubber pads. Apply the pads to the
underside of each device by placing the pad in the marked area at each corner of the switch, ensuring
that all corners aligned. You can safely place up to four Summit family switches on top of one another.

Removing a Summit Switch from a Rack (AC Units Only)

To remove the Summit switch from a rack:
1 Remove power from the switch.
Unplug the power cables from the from the wall outlets first and then from the switch.
2 Disconnect the Summit switch from the redundant power supply (if applicable).
3 Loosen and remove the four screws holding the switch in place in the system rack.
4 Carefully remove the switch from the rack and place it on a secure, flat surface.
NOTE
For information about DC-powered units, see
on page 91.

Installing and Removing Summit DC-Powered Switches

This section provides additional details about installing or removing the following Summit DC-powered
switches:
Summit X250e-24tDC
●
Summit X250e-24xDC
●
Summit X250e-48tDC
●
Summit X450a-24tDC
●
Summit X450a-24xDC
●
Summit X450a-48tDC
●
You must adhere to specific safety requirements when you connect or disconnect a DC power source for
one of these Summit switches.
86
86.
"Removing a Summit DC-Powered Switch from a Rack"
"Installing and Removing Summit DC-Powered
Summit Family Switches Hardware Installation Guide