SNBC BTP-M300 Service Manual page 23

Rem move the tw wo ST2.9x6
figur re with the e cross s
disa ssemble the e vertical pa
1) Remove th he two scr
shown in t the figure w
and then ta ake off the pa
press plate ;
2) When lowe r mark sens
the two sc crews (ST2.
screwdriver r and take o
sensor dust tproof cover
Rem move the thr ree screws (
figur re with cross s screwdrive
left s side plate m odule of pap
1) Remove the e one screw
the figure with cross
take off the damping w
2) Remove the e two screws
the figure with cross
take off th e paper fee
31-17.
1) Remove the e one screw
in the figur re with cros
lock frame with a mo
and take o off the horiz
sensor;
2) Remove the e one screw
in the figur re with cros
lock frame with a mo
and take off the ver
sensor.
- 18 -
BT P-M300 Ser rvice Manu
screws sh hown in the
screwdriver, and then
per cabinet.
rews (ST2. 6x6) at ①
with cross s screwdriver,
aper end se ensor and its
sor is equipp ped, remove
.2x4) at ② with cross
off the mark sensor and
r.
(ST2.9x6) s hown in the
er, and then take off the
per cabinet
w (M3x6) at ① ① shown in
screwdriver r, and then
asher;
s (M3x8) at ② shown in
screwdriver r, and then
eding moto or and gear
w (ST2.6x6) a at ① shown
ss screwdriv ver, pull the
oderate forc ce outwards
zontal pape er near end
w (ST2.6x6) a at ② shown
ss screwdriv ver, pull the
oderate forc ce outwards
rtical paper r near end
al
e
n
①
,
s
e
s
d
e
e
n
n
n
n
r
n
e
s
d
n
e
s
d