Appendix 3 Eeprom Setting Table - SNBC BTP-M300 Service Manual

Appendix 3 EEPROM setting table

Address
(HEX)
04 Print width
06 Print speed
12 Paper type
14 CR(0x0D)command mode
16 Baud rate
17 Data bits
19 Stop bit(s)
1B Parity checkout
7D Receiving buffer size
2A Distance from print head to cutter
2C Distance from sensor to print head
2E Top limitation of mark length
30 Cutter enabled
35 Distance between print position to mark
37 Distance between cut position to mark
40 Serial software handshaking
44 Stop printing when paper near end
58 Buzzer enabled
7E Sending data when powered on
User can configure EEPROM by command:
ASCII
[Format]
Hex
Decimal
0≤n≤127
[Range]
a1 = 92h
a2 = 9Ah
[Description] Write a WORD type data to EEPROM address specified by n, data1 is low-bit data and
data2 is high-bit data. After changing the EEPROM configuration, the configuration will be
effective only after restarting the printer.
Instruction
ESC s B
1B 73 42
27 115 66
Value range and description
0: 76mm,1: 69.5mm,2: 57.5mm
416-1000 steps/second
0: Continuous paper, 1: Marked paper
0: Paper not feed, 1: CR equivalent LF
0: 9600,1: 19200,2: 38400,3: 57600
7: 7bits, 8: 8 bits
1: 1 bit, 2: 2 bits
0: None, 1: odd, 2: even
0: 4096Byte, 1: 40Byte
Indicated by feeding steps
Indicated by feeding steps
Indicated by feeding steps
0: Disabled, 1: Enabled
Indicated by feeding steps
Indicated by feeding steps
0: Disable software handshaking;
1: Enable software handshaking
0: Does not stop printing when paper near end;
1: Stop printing when paper near end
1: Enabled 0: Disabled
0: disable1: enable
E a1 a2 data1
45 92 9A data1
69 146 154 data1
- 43 -
BTP-M300 Service Manual
data2 n
data2 n
data2 n