SNBC BTP-M300 Service Manual page 26

Rem move the two o screws (S
figur re with cross s screwdrive
print t head and r ribbon guide
1) Take off th he two "E"-
guide sha aft
sharp-nose e pliers;
2) Turn the e eccentric bu
sides at the e arrow ① sh
eccentric b bushings to
notches of t the side plat
3) Take off the e left side ec
right side e eccentric bu
and ③ show wn;
4) Take off the e guide shaft
Rem move the tw wo screws (S
figur re with cro ss screwdr
ribbo on support p plate module
Disa assemble th e spring sh
shar rp-nose plier rs.
- 21 -
BT P-M300 Ser rvice Manu
ST2.6x10) sh hown in the
er, and then take off the
e.
rings at bo oth sides of
shown in the f figure
shing at lef ft and right
hown so as to make the
o superpos e with the
te;
ccentric bush hing and the
ushing at th he arrow ②
t at the arrow w ③ shown.
ST2.9x6) sh hown in the
river and ta ake off the
e.
hown in the figure with
al
e
e
f
with h
t
e
e
e
②
.
e
e
h